U
SER
M
ANUAL
P
RODUCT DESCRIPTION
27
The wake input allows waking up the Minilogger Z7 from sleep. To that end,
the wake signal must shift from 0 V to +12 V.
BroadR-Reach LEDs (L):
The housing label
OABR
stands for
OPEN Alliance BroadR-Reach®
.
Port LED is lit green when a connection to a BroadR-Reach component is
established.
Terminators (M):
Configure the built-in terminators for the CAN and FlexRay interfaces via
rotary switches on the back side of the Minilogger Z7.
(
Configuring terminators)
Log interfaces (N):
The slots can be variably equipped with up to five interfaces.
Slot and channel number of each hardware interface are also displayed in
multiple locations of the X
ORAYA
Suite tool
Configuration
:
(
Interface configuration)
Main overview for all interfaces
Main overview for all channels of one interface type
Settings for the corresponding interface channel
Pin assignments can be found in the relevant section.
(
Minilogger Z7 pin assignments)
BroadR-Reach interface (O):
The housing label
OABR
stands for
OPEN Alliance BroadR-Reach®
.
This interface is not part of the log interface slot system
(N)
but
implemented as an add-on board.
LIN power supply internal/external (P):
Use the internal power supply of the LIN measurement card only if the
connected LIN device uses the Minilogger Z7 voltage as a reference voltage.
Bear in mind that this is not possible when using the Minilogger Z7 in a 24-V
electrical system, for example. In this case, connect the external power
supply port to the corresponding reference voltage.
