a
INSTRUCTION
EN
CLICK
6.2.2 Group II III(15-36kg)
6.2.2.1 Installed in forward facing position with ISOFIX
connector and Belt or only Belt
NOTE: When you use this safety car seat in group II
Ill, please remove the 5-point harness, refer to
Chapter 5.7 Place the child seat forward facing on the
vehicle seat (in the direction of travel). Put the ISOFIX
insert guide into the two ISOFIX attachment points of
your vehicle. If you don't have ISOFIX insert guide,
please Ignore this step.
NOTE: The ISOFIX attachment points are located
between the surface and the backrest of the vehicle
seat.
Press the ISOFIX button to pull out the two locking
arms from the base bottom. Pull the locking arm to
and fro until you hear an audible CLICK which
indicates they are fully engaged. And on both sides of
the locking arms’ button turn into green safety
color.(see p22 picture a)
First pull out the belt from the belt ALR. Diagonal belt
through the same side of belt guidance
, lap belt
through the same side of belt guidance
Ώ
, then pull
the diagonal belt and lap belt together through another
side of belt guidance
Ώ
.
NOTE: Keep the diagonal belt at the position of
shoulder between the outside of the neck and
shoulder( Middle of point A and B ).(see p26 picture a)
Lock the tip of the buckle into the vehicle seat buckle
with a CLICK noise. Follow the direction of arrow to
tighten belt, and put redundant belt into cloth cover.
Shake the child safety car seat to make sure it is
securely attached.
CAUTION! The diagonal seat belt section must run
diagonally backward. You can adjust the course of the
belt with your vehicle's adjustable belt deflector on
both sides.
a
A
B
Ensure the lap
belt is as close as
possible to lower.
Ensure the lap
belt is on the
pelvis, not on the
abdomen.
CKLCK
