NUNA
PIPA LITE R
Type:
Rear
-
facing
-
only; must be used
with base in vehicle.
Last date made:
Current
First made:
2020
Weight limits:
4 to 32 lbs.
Harness:
5 point harness
Harness:
Shoulder straps are attached to a splitter plate behind seat. Pull
strap end in front of seat to tighten harness. Push button at lower front of
seat and pull on shoulder straps to loosen.
Harness slots:
There are three sets of slots. To change shoulder strap slot
height, remove straps from splitter plate on back and rethread through
desired slots, then reattach to splitter plate. Harness straps must be
between child restraint and attachment bar (diagram 1).
Crotch strap:
Adjustable. There are two slots; length is also adjustable.
Crotch strap is sewn to a metal anchor which must lie flat against
underside of seat. Use position closest to, but not under, child. To change
position, turn metal anchor sideways, feed through slot, and insert into
desired slot. To shorten length for smaller child, feed metal anchor down
through inner slot and up through outer slot (diagram 2).
Angle adjustment:
Recline adjustment button and indicator are
located on both sides of the base (diagram 3). To adjust, push button
all the way down and slide installed carrier or top of base into desired
position. Use positions 1 or 2 for child weighing 4 to 20 lbs. and
positions 3 or 4 for child weighing 21 to 32 lbs. Recline button must
pop back up to indicate recline is locked.
Belt path:
If lower connectors are not in use, leave connectors
rotated in place on side of base (diagram 4).
Do not install restraint
using inflatable safety belt.
SEE PAGE 2
Important: This information sheet is not a substitute for complete manufacturer
’
s directions and current recall list.
SafetyBeltSafe U.S.A., P.O. Box 553, Altadena CA 91003 (310) 318
-
5111 (800)745
-
SAFE ©SafetyBeltSafe U.S.A. #450 06/21
P. 1 of 3
2
1
3
4
Summary of Contents for PIPA LITE R
Page 4: ...IM 000016F ...
