INSTRUCTION
EN
Pull out the top tether,and press the release
button, pull the top tether long enough to hang the
latch on the back of the car seat.
Fix the latch on the fixed point,and the position of
the fixed point are shown in the picture (one of the
three positions). Make sure the top tether clip is
tightened up.
6.2 Installed in Forward facing position
6.2.1 Group I(9-18kg)
Put the ISOFIX insert guide into the two ISOFX
attachment points of your vehicle.
If you don't have ISOFIX insert guide, please ignore this
step.
NOTE: The ISOFIX attachment points are located
between the surface and the backrest of the vehicle seat.
Press the ISOFIX button to pull out the two locking arms
from the base bottom. Pull the locking arm to and fro until
you hear an audible CLICK which indicates they are fully
engaged. And on both sides of the locking arm’s button
turn into green safety color.
At this time, you can push it as far as possible into the
back of car seat.
Pull out the belt from belt ALR slowly.
Shoulder belts pass through the gap between the
headrest and the seat back, one
side of diagonal belt through the backrest and Belt
Guidance
Ώ
.
Another Side along upper inside. Lap belt pass
through Belt Guidance
Ώ
on both sides.
Using your knee to press down on the child seat,
tighten the vehicle seat belt as follows:
Pull on the lower part of the diagonal seat belt
section near the vehicle seat buckle to tighten the
lap belt section.
Note:
The path should between the headrest, the
sleeping pad and the back of the seat.
Ύ
The path should between the sleeping pad and
the cover of the seat.
(see p23 picture a)
6.2.1.1 Installed in Forward facing position with Belt
or Belt and ISOFIX connector
ISOFIX connector
is optional, you can
ignore this step if you
don't want to use it
a
