Xlink ITC-BT, Owner'S Manual

Page: 11 / 24

When a cell phone that has been paired and is currently connected with the
XLink rings, all telephones plugged into the XLink will also ring.
Each line has its own distinctive ring pattern, allowing you to immediately know
which cell phone the current call is coming in on.
SeleCTInG lIne
reCeIvInG a Call
After.picking.up.a.telephone.connected.to.the.XLink,.you.should.hear.a.steady.dial.
tone,.if.you.hear.an.error.tone.(series.of.rapid.beeps),.there.are.no.lines.available.for.an.
outgoing.call..In.this.case,.check.to.ensure.that.you.have.at.least.one.cell.phone.paired.
and.connected.to.the.XLink.
The XLInk uses the lowest line number with a connected cell phone for outgoing
calls. For example, if cell phones for lines 2 and 3 are connected, all outgoing
calls will be made on line 2.
A specific line can be specified on a per call basis by first dialing the desired line
number and then pressing the FLAsh key on your telephone.
Example: To specify line 3 for an outgoing call, dial 3 FLAsh , then dial the
intended phone number.
Anytime a rapid series of beeps is heard instead of normal dial tone, that
specific line (or any line) is not available for outgoing calls. This is because the
XLink has not been paired with a cell phone or the cell phone is out of range.