2. The mini-card will only fit in one direction. Align the small
notch in the module with the socket on the connector and insert the
card at an angle of approximately 30 degrees into the empty socket.
Then press it firmly so that the contact edge is driven into the
receiving socket. Pivot the mini-card and fasten 2
Screw-F’s to hold the card down.
Note:
If you want to remove the mini-card from the socket, remove 2 Screw-F’s.
The card should pop up to an angle of 30 degree.
3. Locate the 2 antenna cables with main connector. Snap the
cable onto the golden connector on the wirelss mini-card.
(Note:
The connectors are very small! This may take some
maneuvering. You may want to connect the antenna cables
before inserting the wireless card into the socket. )
4. Replace the System Device Cover and 9 Screw A’s.
