4. Remove the System Device Cover. The DIMM socket is
now seen as shown below.
5. If you need to remove an old DIMM from the socket, press out on
the latches located on both edges of the socket at the same time.
The DIMM should pop up to an angle of 30 degree (see diagram
below). Pull the DIMM module out of the memory
socket. Store away the DIMM for the future use.
6. Install the new DIMM module into the memory socket. The
DIMM will only fit in one orientation. Insert the DIMM at an angle of
approximately 30 degrees into the empty memory socket.
Then press it firmly so that the contact edge is driven into the
receiving socket.
7. Pivot the DIMM until the latches on both sides of the socket
snap into place.
Note:
Notice the notch on the DIMM. The notches should fit nicely with the
socket.
