CHAPTER 3
Windows NT 4.0 Installation
Follow the procedure below to install the RealPort Ethernet 10/
100+Modem 56 under Windows NT 4.0. For additional informa-
tion, see the file HELPDOCS.HLP on the Windows 95/98/NT
Installation Disk. For unattended install instructions, see
www.xircom.com.
PCMCIA Services Verification
1
Select Devices from the Control Panel.
2
Scroll down the Device list to the PCMCIA device. The Status
should be Started and the Startup should be Boot. If this is not
how PCMCIA is configured, then click Startup and set the
Startup Type to Boot and click OK.
Network Driver Installation
3
Shut off power to the computer (power down).
4
Insert the Xircom RealPort Ethernet 10/100+Modem 56 into the
PC Card slot in the computer.
5
Power up the computer.
6
Select Network from the Control Panel.
7
Select the Adapters tab and click Add.
8
On the Select Network Adapters screen, click Have Disk. Insert
the Xircom Windows 95/98/NT Installation Disk and verify that
the specified path (for example: A:\) is correct. Click OK.
9
Select Xircom Ethernet 10/100 + Modem 56 and click OK.
10
At the Xircom Ethernet 10/100 + Modem 56 Setup screen,
choose appropriate settings. Click OK.
11
At the Network screen click Close.
12
At the Network Settings Change screen, remove the Xircom
diskette from the disk drive and click Yes.
Do not remove
the RealPort Ethernet 10/100+Modem 56 from the PC
Card slot.
The computer will shut down and restart.
