XIONEER Vortex EZ, User Manual

Page: 15 / 41

Page 15
Flushing the solvent
The dyeing solution will become depleted once you dyed
several kilograms of your materials and will become
ineffective at dyeing further materials.
Note: Make notes on the amount of materials
dyed in order to renew the dyeing solution in
time.
Caution: Wear protective equipment (gown,
goggles and gloves) when emptying the tank.
Caution: Never empty dyeing solution while it is
still hot. Always wait until the dyeing solution has
cooled down.
When emptying the tank, make sure to follow these
steps:
1. Switch off the Vortex EZ and disconnect the
power plug. Allow the dyeing solution to cool
down.
2. Have another container ready if you do not have a
drain nearby. We recommend using a household
drain or a graywater container.
3. Never carry the Vortex EZ with the dyeing solution
inside!
4. Connect a hose to the valve on the left side of the
Vortex EZ . Make sure the hose is secured. Do not
use tools to tighten the connection.
5. Place the other end of the hose into a drain or gray
water container with a minimum capacity of 38
liters and secure the hose from falling out.