Xilinx Kria KV260, User Manual

Page: 10 / 26

USB3.0
There are four USB3.0 interface ports available on the KV260 Starter Kit carrier card. Each port
can deliver a 5V supply to the attached I/O peripherals with up to 900 mA per port. All ports are
protected against an over-current event through individual 900 mA power switches per port.
Note: The total current (across all four ports) is allocated at 2.1A.
Pmod Connector
The Pmod interface (from Digilent Inc.) is supported by the 3.3V, 100 mA capacity on the supply
pin.
Raspberry Pi Camera Interface
The Raspberry Pi camera 15 pin interface connector is supported by the 3.3V supply voltage on
the supply pin.
IAS Module Connector
The SOM supports two IAS module connectors, as defined by the ON Semiconductor IAS
module definition standard. The KV260 Starter Kit carrier card provides 2.75V, 1.8V, and 1.2V
supply rails on specified power pins.
Fan and Heat Sink
The KV260 Starter Kit is built with an integrated active cooling solution (see Figure 2 ). The
integrated fansink allows you to exercise the full 10W Zynq ® Ult™ MPSoC application
power budget without any additional accessories.
Out of the box, the 12V fan should already be plugged into the starter kit. If it is not, be sure that
the fan is plugged into the connector designated in
Table 2 . The fan connector is keyed to ensure
proper orientation.
By default, the fan runs at a constant speed. Variable fan speed control can be implemented
through a FPGA based PWM fan controller. The fan gating signal is connected to a FPGA HD I/O
bank pin for control. Consult the corresponding KV260 Starter Kit carrier card schematic for
specific pin assignment and Xilinx SOM source code repositories for an RTL implementation that
can be integrated with your design.
Chapter 2: Initial Setup
UG1089 (v1.2) July 26, 2022 www.xilinx.com
KV260 Starter Kit 10
Send Feedback