AMS101 Evaluation Card User Guide
www.xilinx.com
15
UG886 (v1.3) November 6, 2013
Quick Start
Ensure that all the jumper settings are correct on the AMS101 evaluation card.
Figure 2-5
shows an example of jumpers J3 and J5 (DACs enabled).
Table 2-1
explains additional
jumpers.
Note:
The image in
Figure 2-5
is for reference only and might not reflect the current revision of the
board.
X-Ref Target - Figure 2-5
Figure 2-5:
AMS101 Evaluation Card Jumper Configuration
UG
88
6_c2_05_092612
1
2
3
6
7
4
5
2
Table 2-1:
AMS101 Evaluation Card Jumper Configuration Notes
Callout
Reference
Designator
Component
Description
Notes
Schematics
1
J2
Jumper
External signal source to V
P
positive analog input.
Figure A-2, page 49
2
J3
Jumper
1–2 selects DAC signal source.
2–3 selects external input source on J2.
Figure A-2, page 49
3
Connector
20-pin connector to XADC header on FPGA base board.
Figure A-2, page 49
4
J5
Jumper
1–2 selects DAC signal source.
2–3 selects external input source on J6.
Figure A-2, page 49
5
J6
Jumper
External signal source to V
N
negative analog input.
Figure A-2, page 49
6
DAC
16-bit DAC sets analog test voltage.
Figure A-1, page 48
7
Amplifier
Reference buffer for DAC.
Figure A-1, page 48
