18
Ethernet settings
IP ADR
A unique IP address should be assigned to each unit in the network.
GATEWAY
The gateway address of the network. Usually this should be the IP address of your router/switch/hub address.
SUBNET
This sets the subnet mask used by your network.
Communication settings
NOTE: The user must power cycle the unit for this setting to take effect.
BAUD RATE
Sets the baud rate of the serial communication. XConsole uses a Baud rate of 115200. This should be left
unchanged for most users.
DEVICE ID
This control assigns a device ID from 1 to 16 to the unit.
NETWORK ID
This control assigns a network ID from 0 to 60000 to the unit. The ID is used for future network expansion
only. Please leave this at 0.
Security lock and unlock
PASSWORD
The password is four characters in length. The factory default of a new unit does not require a password.
The device can be protected for unauthorized parameters and/or system abuse. The security settings can be
controlled and stored in the device with the XConsole GUI only. When the correct password is entered in the
device, all the locks are disabled. After re-entering the password or power cycling the device, the locks are
automatically enabled again.
SYSTEM-SETUP
MENU: Ethernet
IP ADR:
255.255.255.254
GATEWAY: 255.255.255.255
SUBNET:
255.255.255.255
SYSTEM-SETUP
MENU: Comm
BAUD RATE: 115200
DEVICE ID:1
NET ID: 0
SYSTEM-SETUP
MENU: Security
PASSWORD:________
XD Series: System menu
Summary of Contents for XD-4080
Page 1: ...1 XD User Manual...
