What’s new in 1.7.3
1. Rotate encoder driver is op�mized, smoother and less loss of step
2. Total RF GAIN=1/4 RF GAIN se�ng when AGC is off, prevent sudden volume
increase
3. Rx volume step is op�mized
4. Lower the MIC GAIN, prevent picking up too much background noise
What’s new in 1.7.2 (experimental version)
1. CW �ming is op�mized, solved the issue of randomly losing DOT/DASH.
2. T/R switch �ming is op�mized, faster switching �me (t<=53ms).
7. Added microphone filter of SSB mode to a�enuate par�al low frequency
component of microphone signal and improve emission efficiency
8. Changed the color of lines in frequency spectrum picture into green and fill
color into semitransparent green
9. Op�mized the encoder to prevent it from interference or impulse as the
first one
10. Op�mized stack and enhanced the stability
11. Op�mized the control characteris�cs of AGC and ALC
12. Fixed the bug of channel storage func�on
13. Fixed the spectrum display bug during emission
14. Fixed the bug of standing wave detec�on threshold
15. Fixed the problem of interrupted voice during low power emission
.
Updated version number can be checked in 10th item of system menu. It
takes about 3s to read version informa�on once entering this item)
VISIT RADIODDITY.COM FOR DOWNLOADS AND HELP
48
3. Add ALC meter, display below the TX power meter when TXing. It is mainly
for digital mode, to get the good linearity. adjust driving level or Line IN
volume to make the ALC meter value within 30~90. Max level of Line IN
should not be more than 600mVp-p, or it will overload the input amplifier.
4. PO meter is op�mized, more accurate.
5. Rotate encoder driver is op�mized, less losing of steps.
6. ACC LINE OUT is op�mized, main volume will not affect its output level
anymore.
