17
Fault Codes
If the cooking robot is not working properly, the screen will show an error code. Please refer to the table below to
nd the
corresponding solutions.
The pot lid is
not detected.
Possible Causes
Solutions
Fault Codes
The pot is not
detected.
The pot lid is not put or locked in place.
The pot is not installed or is installed incorrectly.
Put the pot lid in place and press
rmly,
then try again.
Align the pot to the correct position and
install it, then try again.
Please contact the a
er-sales service
team to arrange maintenance.
Please contact the a
er-sales service
team to arrange maintenance.
Please contact the a
er-sales service
team to arrange maintenance.
Please contact the a
er-sales service
team to arrange maintenance.
Please contact the a
er-sales service
team to arrange maintenance.
Please contact the a
er-sales service
team to arrange maintenance.
Please contact the a
er-sales service
team to arrange maintenance.
Please contact the a
er-sales service
team to arrange maintenance.
Please contact the a
er-sales service
team to arrange maintenance.
Please contact the a
er-sales service
team to arrange maintenance.
E-03
E-04
E-05
E-07
E-8
E-10
E-11
The overvoltage protection is triggered.
The overvoltage protection is triggered.
The IGBT sensor is damaged.
The sensor at pot bo
om is damaged.
Heating communication has an error.
E-12
The coil plate has an open circuit.
High-temperature alert is triggered by
the sensor at the pot bo
om.
The IGBT temperature is too high.
The cooking robot will automatically
resume working when the voltage goes
back to normal.
The cooking robot will automatically
resume working when the voltage goes
back to normal.
The cooking robot will automatically
resume working when the temperature
goes down.
The cooking robot will automatically
resume working when the temperature
goes down.
E-16
E-17
E-18
E-19
E-21
The motor overcurrent protection is triggered.
The motor high-voltage protection is triggered.
The motor low-voltage protection is triggered.
The motor phase loss protection is triggered.
The motor temperature is too high.
E-13
The pot is not locked in place.
E-20
The motor jam protection is triggered.
The cooking robot will automatically
resume working when the temperature
goes down.
Please contact the a
er-sales service
team to arrange maintenance.
E-22
The motor sensor has an open circuit.
Please contact the a
er-sales service
team to arrange maintenance.
E-23
The motor sensor has a short circuit.
Summary of Contents for MI MCC01M-1A
Page 2: ......