OPERATIONAL INSTRUCTIONS
11
Loop Pad
Steel Ring
LOAD ADJUSTMENT
The resistance of the shock can be adjusted by twisting the adjustment
knob at the top of the shock. There are settings from 1 to 12. Setting #1
will provide the lowest resistance. Setting #12 will provide the highest
resistance.
CAUTION:
The shock gets
HOT
after a few minutes of use.
PEDAL STRAP ADJUSTMENT
If you feel it is more comfortable for your workout, you can change to attach the
PEDAL STRAP(35)
to the
upper position in the
PEDAL(34)
as shown in illustration 1 below. Run the
PEDAL STRAP(35)
through the
opening from the bottom of the
PEDAL(34),
then go through the Steel Ring. Slide the Steel Ring down to
against the
PEDAL(34).
Run the
PEDAL STRAP(35)
through the opening in the
PEDAL(34)
on the other
side from the top as shown in the illustration 1, then make the end of the
PEDAL STRAP(35)
go up to
attach onto the upper part of the
PEDAL STRAP(35)
with the Hook & Loop Pad.
Attach the end of the
PEDAL STRAP(35)
to different position with the Hook & Loop Pad to adjust the length.
Refer to illustration 2.
1.
Hook &
2.
Hook & Loop Pad
End of Pedal Strap
The safety and integrity designed into the
X-FIT 2125
can only be maintained when is regularly
examined for damage and wear. Special attention should be given to the following:
1. Pull on the
HANDLEBARS(17, 18)
and verify that the
SHOCK(22)
provides tension.
2. Clean the roller tracks in the
CENTER BEAM(1)
with an absorbent cloth.
3. Verify that all nuts and bolts are present and properly tightened. Replace missing nuts and bolts.
Tighten loose nuts and bolts.
4. Verify that the
WARNING LABEL(67)
is in place and easy to read. Call Stamina Products immediately
at 1-800-375-7520 for a replacement
WARNING LABEL(67)
if it is missing or damaged.
5. It is the sole responsibility of the user/owner to ensure that regular maintenance is performed.
6. Worn or damaged components must be replaced immediately or stop exercising until repair is
made.
7. Only Stamina Products supplied components should be used to maintain/repair the machine.
8. Keep your
X-FIT 212
clean by wiping it off with an absorbent cloth after use.
MAINTENANCE
Adjustment
Knob
Mark
