46
Overtaking signal
Warning lights
When overtaking, turn on the left turn signal
in advance, pull up the light switch, the
driving beam is on, let go after the switch
back to the initial position, the driving beam
is off.
When overtaking, continuously pull the light
switch upward to send out the overtaking
signal.
The hazard warning light switch is located in
the console. When the hazard warning light
is turned on, the turn signal flashes, and the
combination instrument flashes. The turn
signal switch does not work when the hazard
warning light is on. Hazard warning lights
should be used to draw the attention of other
vehicle drivers when:
1. Unable to continue driving because the
vehicle had broken down.
2. In a traffic jam, the cars are at the end of
the stream.
3. Emergency traction of other vehicles or
when being towed.
WARNING
• When driving at night on roads without
central isolation facilities or without
central lines, do not use driving beams
within 150 m of approaching vehicles
from the opposite direction.
• Do not use driving beams on narrow
bridges or narrow roads without central
isolation facilities or centerlines to
meet non-motor vehicles.
• Do not use driving beams when turning
through an intersection controlled by
traffic lights.
• In the case of no street lamps, poor
lighting or low visibility in the case of
fog, rain, snow or dust, the following
vehicle driving in the same direction
shall be in close proximity to the
leading vehicle driving in the same
direction.
• Through the sharp bend, slope, arch
bridge, crosswalk or no traffic signal
control intersection, should alternate
the use of driving beams, passing light
signal.
Charging
device
Lighting
device
Vehicle
device
Emergency
treatment
Technical
information
Instrument &
control devices
Safety
device
Starting &
driving
Repair &
maintenance
