Configuring SNMP
System Administrator Guide
4-18
8.
Click the
Configure Account(s)
button. A series of pages display that enable you to
configure SNMP v3 and the
Administrative User
,
Key User
, and
Any User/Driver
settings. The first page displays Administrative User account information after the account
has been created.
9.
Do one of the following:
■
To create the Administrative User account and to enable SNMP v3, enter a user name
or accept the default name
admin
, and then click the
Create
button.
■
To configure the Key User and other account settings, click the
Next
button.
■
To delete the Administrative User account and disable SNMP v3, click the
Delete
button. This also deletes all other accounts, including the Key User and Any User
settings.
Configuring the SNMP Access Control List
To set up a list of hosts that are authorized to access the printer using SNMP:
1.
Launch your web browser.
2.
Enter your printer’s IP address in the browser’s
Address
field (http://xxx.xxx.xxx.xxx).
3.
Click
Properties
.
4.
Select the
Protocol
folder on the left sidebar.
5.
Select
SNMP
.
6.
If prompted, enter your Admin or Key User name and password.
7.
Enter up to ten host IP addresses in the
SNMP Access Control List
field. Separate entries
with a blank or a comma, specify ranges with a hypen (-), and use an asterisk (*) to
represent a group of numbers (e.g., 13.62.156.*).
8.
Click the
Save Changes
button.
9.
If prompted, enter your Admin or Key User name and password.
See also:
About Access Control Lists
on page 4-4
