Xerox Phaser 6250DT, Service Manual, Page: 301 / 467

8-82 Phaser 6250 Color Laser Printer Service Manual
Toner Present Switch Bracket and Actuator (PL 10.1.6
and 10.1.22)
1.
Remove the Imaging Unit and protect it from exposure to light.
2.
Remove the Top Main Cover, see page 8-9.
3. Remove the Left and Right Side Covers, see page 8-11.
4. Remove the Rear Cover, see page 8-12.
5. Remove the Cartridge Holder screws on each side working from the Yellow
cartridge back to the cartridge that is to be removed.
Note
When removing the Black cartridge, remove only the screws for that
cartridge.
6.
Disconnect P/J 51 from the Motor Driver Board.
7.
Starting at the Yellow cartridge, disconnect the motor connector and remove
wires from the cable retainers.
8.
Beginning with the Yellow, slide the toner holder slightly to the right just far
enough to clear the left alignment pin, then lift first the right end and then the left
end of the holder.
Note
It may be necessary to disconnect the Toner Low Sensor connectors (P/J 701
Y, P/J 702 M, P/J 703 C, and P/J 704 K) to move the holder out of the way.
9.
Move the holder out of the way and proceed with the next one until the desired
cartridge is reached.
10.
Remove the Toner Cartridge.
Note
Rotate the Toner Holder Assembly with the switch facing up before
removing the switch to prevent toner spills.