Xerox DP 1015, User Manual

Page: 38 / 46

Xerox DP1015 User’s Guide 33
Maintenance
Problem: When the projector is connected to a DVD
player, playing a film with a 16:9 aspect ratio makes the
image looks stretched out.
Try one of these possible solutions:
• Reset your DVD player to display at a 4:3 aspect ratio. See the
DVD player user’s guide for the steps to adjust its aspect ratio.
• Using the OSD Menus, go to the Display Menu page and select
a new Proportion. Change the Proportion to 4:3.
Problem: The colors of the projected image look different
than the colors of the image on the computer screen.
Use the OSD Image and Display menus to adjust the colors.
Problem: Image is reversed.
Use the OSD Management Menu to change the projection
direction to display the image properly.
Problem: No sound.
Make sure the audio cables and other cables are connected
properly.
Problem: Remote control does not work.
Check for one of these possible problems:
• Are you too far from the projector? The remote control has a
range of 29.5 ft (9m). Move closer to the projector and try the
remote control again
• Is anything blocking the infrared sensors on the projector?
Make sure the infrared sensors are not covered or blocked
from receiving signals from the remote control.
• Are the batteries in the remote control dead? Replace the
batteries in the remote control.
Problem: Lamp burns out or make a popping sound.
When the lamp reaches its end of life, it will burn out and may
make a loud popping sound. If this happens, the projector will not
turn on until the lamp module has been replaced. See “Changing
the Lamp” on page 27 to replace the lamp. If the lamp burns out
while in the projector, it may crack and scatter glass shards into the
projector which can block a blower fan and stop it from turning.