Xerox DP1015 User’s Guide
13
Connecting the Projector
To turn off the projector power
1. Press the
Power
button on the projector or remote control to
turn off the projector lamp.
An on-screen message appears asking if you’re sure you want
to turn off the lamp.
2. Press the
Power
button again to confirm.
If you don’t press the button within ten seconds, the message
disappears and the lamp remains lit. This convenient design is
in case you accidently press the
Power
button in the middle
of a show and do not want to turn off the projector.
If you do press the
Power
button a second time, the
LED indicator flashes rapidly. Then the projector automatically
shuts itself down.
3. Do not turn on the projector again for at least two minutes.
When the LED indicator is again flashing slowly it is safe to turn
the lamp back on.
4. After two minutes, disconnect the power cord.
LED Indicator
•
Slow flash
—Normal operation; the power cord is plugged in.
•
Steady light, not flashing
—Normal operation; the lamp power
is on and the projector is operating normally.
•
Rapid flashing during lamp shutdown
—Normal operation;
the fan runs for about 30 seconds to cool down the lamp.
•
Rapid flashing while the lamp is powered
—
Warning
: either
the lamp has overheated and the fan runs automatically, or the
fan has malfunctioned. You cannot turn off the power to the
lamp until it has cooled down.
NOTE:
Do not disconnect the power cord until the projector’s
cooling fan stops (about two minutes). This protects the lamp
from overheating and possible damage
LED Indicator
Summary of Contents for DP 1015
Page 1: ...DP 1015 projector user s guide...
Page 2: ...Xerox DP1015 projector user s guide...
Page 43: ...Maintenance 38 Xerox DP1015 User s Guide...
Page 46: ...05 0603 000...
