Using the Finisher
Chapter 3: Printing
❖
3-35
Job Offsetting
The finisher supports offsetting of printed jobs in all three
bins.
Supported Paper Sizes
All sizes of paper can be sent to the finisher except A6 and
Envelopes. Mixed sizes of paper can be sent to the finisher
bins as long as all the paper within a single job is the same
size. Mixed paper sizes
within the same job
cannot be
compiled and stapled. See Table 3.7 on page 3-37 for
supported paper sizes.
Output Destination
With a finisher installed, the user may select the following
output destinations: Face Down Bin, Face Up Bin, Finisher
Bin 1, Finisher Bin 2, and Finisher Bin 3. Output
destination can also be set by the System Administrator.
Output Bin Sensing
Each finisher bin senses not only the height of each stack,
but also the number of stapled sets delivered to each
stack. When the number of stapled sets delivered to the
bin reaches 100 for long edge feed (LEF) paper sizes, or 50
for short edge feed (SEF) paper sizes, as shown in Table 3.7
on page 3-37, the bin is reported as full.
