Xerox DocuPrint 96, Operator'S Manual

Page: 84 / 548

PAPER FACTS
2-16 XEROX DOCUPRINT 96/DOCUPRINT 96MX LPS OPERATOR GUIDE
Stacker bins
The Xerox DocuPrint 96/DocuPrint 96MX LPS has one high-capacity
stacker (HCS) bin.
•
You can not lower, pull out, and unload the bin without
interrupting printing.
•
If you select the bin that is in use printing stops.
•
Once a sheet is delivered to the stacker bin, each subsequent
sheet must be within 25 mm of each dimension of the first
sheet.
Refer to table 2-6 for additional information on performance of the
high-capacity stacker bins.
Table 2-6. Stacker bin performance guide
Paper Superior performance Good performance
Performance limits and
suggested alternatives
Size range 8 by 10 to 11.69 by 17
inches/203 by 254 to 297
by 432 mm Smaller or larger sizes cannot be
used.
Weight range 20 to 110 pounds/80 to
200 gsm
Lighter than 20 pounds/80
gsm and no lighter than 16
pounds/60 gsm Weights outside the limits shown
here are not recommended.
Capacity
•
Capacity automatically
limited so stack weight will
not exceed 30 lbs/13.g kg
•
Selectable with bin capacity
programming (Refer to the
“Bin full criteria and setting
bin limits” section of the
“Status and print tasks”
chapter for instructions.
Stack quality
•
Xerographic paper in
good condition
•
20 pound/80 gsm and
heavier stock
•
Very low to no output
curl
•
Lighter weight stocks
with low output curl
•
Intermixed stocks
•
Adjust process decurler
•
Flip paper in paper feeders
•
Limit stack capacity to
acceptable limits.
Type or
condition
•
Xerographic paper in
good condition
•
Predrilled stock
•
No cut-outs,
perforated or
intermixed weights
•
Labels, preprinted
forms, perforated
stocks
•
Intermixed weights
•
High output curl stocks can
cause severe stack quality
problems
•
Tab stock intermixed with
smaller stocks results in
degraded stack quality
•
Reinforced mylar should be
limited to small stacks of 200
sheets or less or sent to the
sample tray