Xerox DocuPrint 96, Operator'S Manual

Page: 421 / 548

PROBLEM SOLVING TASKS
XEROX DOCUPRINT 96/DOCUPRINT 96MX LPS OPERATOR GUIDE 11-25
Step 3. Relatch the paper feeder assembly by pressing down on the bright
green dot (see figure 11-32). Slide the paper tray completely back
into the printer.
Figure 11-32.Relatching the paper feeder assembly
Step 4. Operate the system as usual. If you are still experiencing misfeeds,
place a service call.
Note: This procedure should be used only to correct a
problem, not as a routine maintenance procedure. Because the
belts are made of rubber, frequent cleaning with film remover will
dry them out and cause them to fail prematurely. Film remover
may be obtained from your Xerox service representative.
Faults are cleared but the Attention light is still on
If you have cleared all faults that are listed on the printer control
console, but the Attention light is still on and the message “Output is
stopped. See message at the System Display” appears on the printer
control console, there may be an uncleared output fault. Check the
system controller display. Follow the instructions in the output
message and press the Continue button.
Printing does not continue when the Continue button is pressed
If the Continue button is pressed before all printer faults are cleared,
the outstanding faults are changed to the status of masked faults
(refer to the “Fault masking and the printer control console” section
earlier in this chapter). If the printer status displayed in the message
area of the printer control console is READY, but printing does not
continue when you press the Continue button, touch the Fault List
icon on the printer control console to display the Fault List screen.
(Refer to figure 11-1.) Clear any faults displayed on this screen and
press the Continue button again.