Xerox DocuPrint 96, Installation Planning Manual

Page: 58 / 116

PREINSTALLATION
3-28 XEROX DOCUPRINT 96/DOCUPRINT 96MX LPS INSTALLATION PLANNING GUIDE
Dry ink (toner)
Dry ink (also referred to as “toner”) is the black powder which forms
the image on the printed page. There are three cartridges of dry ink
in each container. Keep an adequate supply on hand at all times. The
operator can change throw-away cartridges easily with no mess. Use
only dry ink that is specified for use in your LPS. (Refer to the
consumable supplies table at the end of the “Postinstallation”
chapter.)
Fuser agent
Fuser agent is a consumable item required by the LPS. Keep an
adequate supply on hand for installation by the Xerox or Xerox
Limited service representative.
Developer
Developer is a required item that needs to be ordered and kept on
hand. It is changed by a Xerox or Xerox Limited service
representative. Use only developer specified for use in your LPS.
(Refer to the consumable supplies table at the end of the
“Postinstallation” chapter.)
Tapes
Each of the tape drives available on the DocuPrint 96/DocuPrint
96MX LPS requires a different tape format.
1/4-inch (QIC) The 1/4-inch QIC tape drive uses quarter-inch stream cartridge
tapes. The tape data capacity should be 320 MB with 225 KB/second
data transfer rate.
36-TRACK The optional 18/36-track tape drive uses 0.5 inch cartridge tapes with
a data capacity of 1.2 GB.
18-TRACK The optional 18/36-track tape drive also uses 0.5-inch IBM 3480-
compatible cartridge tapes with a data capacity of 200 MB.
Cartridges are not available from Xerox.
9-TRACK The optional 9-track tape drive supports reel-to-reel 9-track 1600 bpi
(PE) and 6250 bpi (GCR) encoded magnetic tapes.