Installation Planning Guide
Installation
DocuTech 65/DocuPrint 65
2-9
To remove the monitor:
1. Ensure that the monitor is unplugged from the power strip.
2. Face the back of the monitor.
3. Tilt the back of the monitor upwards
4. Locate the two retainers (one on each side of the base of the monitor,
holding the wire brackets in place).
5. Unscrew the two 12 mm screws from each of the two retainers.
6. Remove the retainers.
7. Save all removed hardware. (You will need this hardware when you
attempt to reinstall the monitor.)
8. With the monitor back tilted upwards, rotate the rear wire bracket
upward, then lift upward to remove.
9. Face the front of the monitor.
10. Tilt the front of the monitor upward.
11. Rotate the front wire bracket upward, then lift to remove.
12. Save all removed hardware. (You will need this hardware when you
attempt to reinstall the monitor.)
13. Lift up the monitor and place it on a wheeled-cart for transport to the
new location.
•
Unlock the printer front and rear right wheels by pressing the lever
upward on each set of casters, as shown in Figure 2-10. Do not attempt to
unlock the left wheels. After the right wheels are unlocked, to enable
better steering and avoid tipping, move the printer from the left to right.