![background image](http://html1.mh-extra.com/html/xerox/docuprint-4512/docuprint-4512_user-manual_3314190065.webp)
I n s t a l l a t i o n i n a W i n d o w s E n v i r o n m e n t
C h a p t e r 5 : T C P / I P C o n f i g u r a t i o n
❖
5-7
If it does not respond, verify that TCP/IP is enabled on the
status sheet. If the status sheet does not show the IP
information, then repeat the above procedures.
Setting up IP and lpr Parameters
The NIC provides for a setup connection via the standard
Telnet
port. To be able to make changes to a unit with factory
default settings, you must logon as
sysadm
. The default
password is also
sysadm
(This password can be changed
from the
Telnet
utility). The section
Running TELNET
(page 5-47) describes the use of the
Telnet
utility.
1.
Telnet
to the NIC (the login and password are both
sysadm
).
2. Turn off the protocols that you are not utilizing (option 3).
3. Setup the subnet mask and default gateway for the NIC if
applicable (menu option 1). (If you used BOOTP, this will
already have been done).
4. Exit, Save and Reset the NIC
Creating an lpr Queue on the Workstation
Once you install the spooler onto the workstation, the setup
program will create a group and icon.
1. Double click on the spooler icon.
2. Click on
setup
, and define a new queue.
3. At the Remote Host Name prompt:
Enter the NIC IP Address, and enter
PORT1
for the
Remote Printer Name
4. Go to Control Panel, Printers, and choose
Connect
.
5. Select your driver and click on
Next
.
At this point, you should see an entry for your Windows lpr
Spoolers printer in the Available ports listing. For example,
C:\SPOOL\PRINTER_NAME.
Book.frm : CHAP5.FRM Page 7 Saturday, October 12, 1996 7:43 AM