Xerox DocuColor 2060, Supplementary Manual, Page: 71 / 216

Printing using Xerox utilities and lpr utilities (DOS and UNIX)
Guide to Submitting Jobs from the Client 3-21
• -C“(bf=<background form>)”
Specifies the name of saved G4 form(s) created using
decomposition services.
• -C“(cf=<n>)”
For a single multi-page Background Form associated with a
document, allows you to specify how to cycle through pages
when you run out of background images before the end of a
document.
The Background Form that will be cycled can be specified in
the same command line: -C“(bf=<formname>,cf=<n>)”.
• -C“(collated)”
Specifies that copies of the job are printed collated. This is
the default behavior.
• -C“(copies=n)”
Specifies the number of copies of each file you want to print.
• -C“(disposition=<savemaskG4 | savemaskBC | saveformG4 |
saveformBC>)”
Sets a virtual printer for decomposition services.
• -C“(drilled)”
Sets the paper type to “drilled.” To use this option, the paper
type at the printer controller must be set to “drilled” using the
Set Tray command.
• -C”(eh)”
Sets the ElideHeader attribute to TRUE.
NOTE: This option acts the same as the -h lpr switch.
However, for some implementations the -C flag interferes with
the -h flag, therefore a -C option is needed.
• -C”(flip)”
Specifies that sheets are to be turned (flipped) over by the
printer before delivering the sheets to the stacker.
• -C“(font=<font>)”
Specifies the font you want to use. You can specify any of the
fonts installed on the printer controller. This option is valid for
ASCII jobs only.