Xerox 721, Operator'S Manual, Page: 71 / 72

USER MODES
XEROX WIDE FORMAT 721P PRINTER OPERATOR MANUAL
63
User Mode b (Image Enhancement) “Ub”
The Image Enhancement Mode is used to improve reproduction of
gray scale. Increasing the setting of this feature increases the
density of single pixels. There can be, however, a noticeable
overall degradation in gray scale images as the setting is
increased. Experimentation will be required to achieve the correct
balance.
If an AccXES controller is used to print to the 721p and the version
of software is 9.2 or higher, than the setting of “Ub” should have no
effect on output quality. The output density can be changed on
WebPMT on the AccXES controller. The setting to change the
darkness of printer output is the Toner Density setting on the web
page “Printer Defaults/Printer Setup/Miscellaneous”. The default
setting is 5 and can be adjusted from 1 (lighter) to 10 (darker).
1) With the printer in the Standby (idle) condition, press the [Menu]
Key 11 times to enter Mode b.
The [Menu] Key lights and the display indicates “Ub”
Press [Enter]
2.) Press the
→
or
←
key to change the value:
0 = No Image Enhancement
1 = Low Image Enhancement
2 = Medium Image Enhancement
3 = High Image Enhancement
NOTE
: Factory default is “0”, No Enhancement
3) Press [Enter] key to store the value.
4) Press the [Online] Key to exit the User Mode.
Menu Enter
Online
Menu Enter Online
Menu Enter Online
Menu Enter Online