Xerox 721, Operator'S Manual, Page: 29 / 72

MEDIA
XEROX WIDE FORMAT 721P PRINTER OPERATOR MANUAL
21
9. Insert the lead edge of the media between the upper and
lower feed rollers.
10. Rotate the green knob in order to feed an inch (25 mm) of
media between the feed rollers.
11. Set the switches for the series and type of media you have
loaded, from rear to front:
•
Arch. (12”, 18”, 24”, 30”, 36”, rolls) or Ansi. (11”, 17”, 22”, 34"
rolls) (Rear)
•
Plain Media
•
Vellum
•
Film (Front)
NOTE:
12. Ensure that the rubber-tracking belt is underneath the plastic
roller on the right side of the media spindle. If the belt is not
correctly positioned, the printer will indicate an out-of-media
condition.
13. Push the drawer in until it is closed and latched.
14. If the leading edge is not sufficiently square, perform the
automatic Initial Cut by pressing the [Select] key to select the
appropriate drawer, and then pressing [Cut] key.
Approximately 9.5” (240mm) media will be cut and fed from
the printer.
Knob
Plain
paper
Tracing
paper
Film
Belt
841