<
cut top 2"
cut 1">
DIIIIIIIIHHHHHHHHIIIIIIIIIIIII
4-2
Printing
SELECTING FONTS
Fonts are selected through your application
software, through printer commands to select a
font, or for PCL 5 at the control panel. The
font you select is used unless you change it.
Fonts are selected by the Xerox Configuration
and Resource Utility for Twinax and Coax
printing.
Default Font for the PCL 5 Mode
You may select a default font for the PCL 5
mode either through a PCL 5 command set,
through your application software, or by
accessing the PCL 5 SETUP option at the Printer
Setup Menu. The default font you select at the
menu is used unless you:
F
Change your selection at the menu.
F
Select a different font through your
application software.
F
Send a printer command to select a font with
your document.
A factory default font has been established for
the PCL 5 mode and is listed on the Printer
Setup Menu for the PCL 5 SETUP.
SENDING A PRINT JOB
Before you begin to print, make sure that the
interface cable or cables between the host
XEROX 4219/MRP Mid Range Systems Printer
XEROX 4215/MRP Mid Range Systems Printer
Summary of Contents for 4215
