Xerox 4215, Operator'S Manual

Page: 239 / 414

< cut top 2" cut 1">
DIIIIIIIIHHHHHHHHIIIIIIIIIIIII
Appendix B
B-1
POWER CORD REQUIREMENTS
The power cord you received with your printer
meets the requirements of the country where you
purchased the product. If you use the printer
in another country, you must use a power cord
that meets the requirements of that country.
For more information on power cord
requirements, contact your Xerox equipment
supplier.
The following information explains the
requirements for power cord selection.
General Information
1. The cord must be approved for the country
where it will be used.
2. The appliance coupler (that is, the
connector to the device itself, not the
wall plug) must have a configuration for
mating with a EN 60320/IEC 320 appliance
inlet (Standard Sheet C14).
3. The length of the cord set must be as
follows:
Minimum 6.50 ft. (2.0 m)
Maximum 9.75 ft. (3.0 m)
U.S. and Canada
1. The cord must be UL-Listed and CSA-
XEROX 4219/MRP Mid Range Systems Printer
XEROX 4215/MRP Mid Range Systems Printer