XE210C Hydraulic Excavator
Operating and Maintenance Manual
89
List 1-9 Parameter list
Machine type
A
XE210C
73600N(7.5T)
XE210C3
Ⅶ
73600N(7.5T)
XE210C2
73600N(7.5T)
XE210C2
Ⅶ
73600N(7.5T)
b)
Hook must be used.
c)
Make sure that steel cable is towed horizontally and in the same direction of crawler.
d)
Choose slow treading mode, drive the machine slowly when towing.
Pay attention when stopping the machine and staying overnight
a)
After finishing the duty of that day, drive the machine to the place where there is no falling stone,
ground collapse or flood, then park the machine on solid and level ground.
b)
Top up the fuel tank
c)
Clean the machine.
d)
In winter, if there is no anti-freeze fluid or cooling fluid
with long lifespan, make sure to drain off cooling water in
radiator and engine. After that, you must also hang up the
plate of “no water in radiator” in visible plate.
Notes for the work
Attention: check working site beforehand
1)
When working on site where some object may drop, you must install a roof protector for cab.
2)
If it is needed to work on soft land, the ground should be fully hardened in advance.
a)
When working on the machine, you must wear tight clothes and other
safety products like safety helmet, which are suitable for work.
b)
Let other person go out of the moving range of the operation and the
machine, clean all the obstruction. During the operation, you should pay
attention to the surrounding all the time, and don’t let the boarding run
into obstruction when working in small area surrounded by obstruction.
c)
While loading the material for the truck, you should lift the bucket
above the truck bucket from the rear of the truck, try not to rotate the bucket above the cab or anyone.
d)
When operating, fence should be installed at the side and rear of the bucket’s rotating radius to
prevent any unconcerned person enter into the working area.
Operate the machine safety
Attention
:
Prevent the machine from rolling over and influenced by ground collapse.
Pay attention to the followings:
a)
Ensure the work site is strong enough to support the machine hardly. When working in ditch or road
shoulder, operate the machine by making the crawler vertical to the wall and the treading motor at the
Fig.1-77
Fig.1-78
Fig.1-79
Hook hole
Chassis bodyframe
Hook
Steel cable