28
|
RAZORWELD™ 205SS MIG/TIG/STICK Welder Manual
INSTALLATION SET UP OF THE
SPOOL GUN
(11)
Unclip and swing open the wire feed housing cover to expose the wire feed mechanism.
(12) Unclip and swing back the wire tension swing arm. Check the that the correct drive roller is installed.
(13) Carefully feed the wire through the drive roller into the inlet guide tube. Swing back and clip down the
wire tension swing arm.
(14)
Remove the gas nozzle and contact tip from the torch neck,
Pull the trigger to drive the wire through
the neck until it exits the contact tip holder.
(15) Check the drive roll pressure is enough to drive the wire smoothly and djust the drive roll pressure if
required by using the adjustment grub screw. Screw clockwise to increase the tension using an Allen
Key tool.
(16) Fit the correct sized contact tip and gas nozzle.
Close the wire feed housing cover, fit the spool
cover,ready for welding.
(17)
Carefully open the gas cylinder valve and set the flow rate to between 8-12 l/min.
(18) Select MIG function and 2 or 4T Trigger function on the front panel.
(19) Set the welding parameters using the wire feed and voltage control knobs.
(11) Unclip and open the wire feed housing
cover
(12) Unclip and swing back the wire tension
swing arm. Check the that the correct drive
roller is installed.
(17) Carefully open the valve of the gas
cylinder, set the Flow to 8/12 l/min
(16)
Fit the contact tip and gas nozzle, close
the wire feed housing cover, fit the spool
cover,ready for welding.
(15) Adjust the drive roll pressure if required
by using the adjustment grub screw. Screw
clockwise to increase the tension using an
Allen Key tool.
(13) Feed the wire through the drive roller
into the inlet guide tube. Swing back and clip
down the wire tension swing arm.
(14) Remove the gas nozzle and contact tip.
Pull the trigger to drive the wire through the
neck until it exits the contact tip holder
(18) Select MIG function and 2Tor 4T trigger
Important: Smart Set programs are for solid
steel wire only.
(19) Set welding parameters using the
wire feed and voltage knobs.