Xcel-Arc RAZORWELD 205, Operating Manual

Page: 27 / 52

RAZORWELD™205SS MIG/TIG/STICK Welder Manual
| 27
Razor Weld
INSTALLATION SET UP OF THE
SPOOL GUN
(1) Select Spool Gun using the Standard/Spool Gun selector switch.
(2)
Connect the Spool Gun to the Euro Mig torch connection socket on the front panel, and tighten it.
IMPORTANT : When connecting the torch be sure to tighten the connection. A loose connection can
result in the connector arcing and damaging the machine and gun connector.
This damage is not covered under warranty.
(3) Insert the weld power cable plug into the Positive socket on the front of the machine and tighten it.
(4) Connect the Spool Gun control cable to the multipin receptacle located on the lower front panel.
(5) Insert the earth cable plug into the Negative socket on the front of the machine and tighten it.
(6) Connect the gas regulator to the Gas Cylinder and connect the gas line to the Gas Regulator.
(7) Connect the gas line to the machine via the quick push lock connector located on the rear panel.
(9) Take the Spool Gun and remove the spool cover.
(10) Place the Wire Spool onto the Spool Holder - Hold and snip the wire from the spool being sure to hold
the wire to prevent rapid uncoiling.
(10) Place a spool of wire onto the Spool
holder.
(9) Remove the spool cover by unscrew-
ing the retaining nut and lifting off the
cover
Caution:
Disconnect the Electrode Holder cable from the machine before using MIG function. If cable is not disconnected welding
voltage is present and can cause Arcing or Flash.
IMPORTANT
Select the correct polarity. Connect the weld
power lead to output terminal.
(6) Connect the gas regulator to the gas
cylinder and tigthen. Connect the gas
line to the gas regulator.
(5) Connect the earth
lead to the terminal
(1) Set Standard/Spoolgun selector
switch inside door to Spool Gun
IMPORTANT :
When connecting the
torch be sure to tighten the connection.
(2) Connect the Spool Gun
(3) Connect the Weld Power
lead to the terminal
(7) Connect the gas line to the machine
inlet gas connector via the quick push
lock connector located on the rear panel
(4) Connect the Spool Gun
control cable