X3102r user manual V. 2.0
28 / 33
If you have any application or server in your LAN
environment, which is available for outside uses, please
configure the PAT (port address translation) table to enable
this kind of service by following the example below,
otherwise continue to section
4.4
Use the following example to set NAT function for PPPoA
routing.
>pat (with
“enter”
key to go to pat director)
>pat> addpatin pppoa 434/udp 210.18.35.10
(Addpatin – command for add incoming pat table)
(pppoa – set PAT table for PPPoA routing. PAT table is
service related)
(434- port number of services or application to offer)
(udp – protocol used. Use ”tcp” for tcp/ip services)
(210.18.35.10 – IP address of server offered for access
from outside. Use correct IP Address instead)
4.4 Save the configuration to router permanently and make
settings effective by following steps below.
>pat> home (with
“enter”
key to execute)
You can use “show” command to check your setting again.
>>save (with
“enter”
key to execute)
Wait until the following message displayed on your screen
completely. Don’t power off the modem during this stage.
Saving configuration...
Configuration saved.
Updating flash filing system ...
SDRAM size = 0x800000
Booting...
System starts...