X3102r user manual V. 2.0
25 / 33
Use the following example to enable NAT function for IPoA
routing.
>pat ( with “enter” key to go to pat director)
>pat>setpat 192.168.1.3 enable
>pat>setpat 192.168.1.3 enable
(Enable NAT function for IPoA routing for specific WAN IP
address. Replace WAN IP address with the specific
address set for IPoA routing in this example. You have to
repeat this command if more than one PVC had been
configured)
(Use the same command with “disable” attribute to disable
NAT function)
If you have any application or server in your LAN
environment, which is available for outside uses, please
configure the PAT (port address translation) table to enable
this kind of service by following the example below,
otherwise continue to section 3.4
Use the following example to add PAT table for IPoA
routing. The word with background “ “ is prompt following
by a command required
>pat> addpatin 192.168.1.3 434/udp 210.18.35.10
(Addpatin – command for add incoming pat table)
(192.168.1.3 – WAN IP address of IPoA routing.
Replaced with specific WAN IP address set for IPoA
routing in this example. PAT table is service related)
(434- port number of services or application to offer)
(udp – protocol used. Use ”tcp” for tcp/ip services)
(210.18.35.10 – IP address of server offered for access
from outside. Use correct IP Address instead)
3.4 Save the configuration to router permanently and make
settings effective by following steps below
>pat> home (with
“enter”
key to execute)
You can use “show” command to check your setting again.
