![background image](http://html1.mh-extra.com/html/xantrex/xw4024-120-240-60-xw4548-120-240-60/xw4024-120-240-60-xw4548-120-240-60_installation-manual_3453913038.webp)
Inverter/Charger Installation
2–14
975-0239-01-01
This manual for use by qualified personnel only
Making DC Connections
This section describes how to make DC connections between the inverter/charger and the
power distribution panel (using the pre-installed DC cables in the distribution panel),
between the distribution panel to the batteries (using battery cables provided by the
installer—see Table 2-2 on page 2–10). This section also provides procedures for installing
the battery temperature sensor. See Appendix C, “Alternate System Configurations” if the
installation will not be including an XW Power Distribution Panel.
To connect the XW Power Distribution Panel to the inverter:
1. Connect the pre-installed DC cables from the XW Power Distribution Panel to the
inverter DC terminals. Figure 2-12 shows the proper stacking order of hardware. Be
careful to observe proper polarity.
2. Attach the DC terminal covers.
3. Route the DC cables from the battery—with the cables not connected to the battery—
and connect them to the XW Power Distribution Panel: negative to negative bus,
positive to the input end of the DC breaker. To properly attach and torque the positive
cable to the DC breaker, you may need to temporarily remove the breaker from the rail.
4. Perform the procedures in “Making AC Connections” before connecting the DC cables
from the XW Power Distribution Panel to the battery.
WARNING: Shock Hazard
Ensure that all AC and DC breakers are switched OFF before connecting or disconnecting the
battery cables and that all sources of power (both AC and DC) are disconnected from the inverter.
Figure 2-11
XW Inverter/Charger DC Connections
Bottom View
Negative (–, black)
battery terminal
Positive (+, red)
battery terminal
BTS port (RJ11)
Chassis Ground
Lug
Battery Temperature
Sensor (included)
(FGA #808-0232-02)
Figure 2-12
Battery Cable Connection
Terminal surface
Copper compression lug
Ensure nothing is between the terminal
surface and the battery cable lug
Battery cable lug
Flat washer
3/8-15 x 5/8” bolt (supplied)
Shrink-wrap to color-code
the cable
Split-ring washer
Summary of Contents for XW4024-120/240-60, XW4548-120/240-60,...
