4. Mount the Charge Controller.
The charge controller is best mounted in a location away from direct
heat, water, salt, snow, ice, and debris.
a.
Mount the unit.
b.
Ensure the heat fins have sufficient air flow.
c.
Use the charge controller flange to create a hole template so
you can pre-drill the mounting holes.
Figure 5 Charge Controller
3
2
4
1
5
1
Communication port (do not
cut or remove)
4
LED lights
2
Battery cables (Power
output) positive (+)with fuse
& negative (-)
5
Thermistor probe (do not
cut or remove)
3
PV cables (Solar Input)
positive (+) & negative (-)
Make sure the in-line fuse (in item 2 above) is connected on the (+)
side of the battery side of the charge controller. If you have a busman
disconnect, make sure it is not near an area where it can disconnect by
touching other cables or components.
975-1172-01-01 Rev A
August 2023
9