97-0020-01-01
39
Installing the Inverter/Charger
This
g
u
id
e for
u
se by qu
alifi
ed installers only.
Step 6: Connecting to the Network
For your reference, Figure 15 shows where the network connections are
made on the Freedom SW.
To connect the Freedom SW to the Xanbus network:
◆
Plug a network cable connected to the Xanbus network into either one
of the two Xanbus Interface network ports on the Freedom SW.
Detailed information on planning and installing your network is available in
the
Xanbus System Installation Guide.
Refer to the this guide to determine
the type of network layout to install, as well as guidelines for installing the
network.
The Xanbus System Installation Guide is available for download at
www. xantrex.com
EQUIPMENT DAMAGE
Connect the Freedom SW only to other Xanbus compatible devices.
Although the cabling and connectors used in this network system are the
same as Ethernet connectors,
this network is not an Ethernet system
.
Equipment damage may result from attempting to connect two different
systems. Do not attach the Freedom SW On/Off switch to these ports.
Failure to follow these instructions can damage the unit and/or
damage other equipment.
Figure 15
Connecting to a Xanbus Network Port
FREEDOM
SW
3012
FREEDOM
SW
3012
In
ve
rter
R
eset Enable
Inve
rter A
C/
Enabled
Xanbus Interface
Stacking
Cha
rge
Fault
Connect only
Xanbus-enabled
devices. Ports
are not intended
for the On/Off
Switch.
Freedom SW 3K2K InvChg Install Guide.book Page 39 Wednesday, October 12, 2011 4:40 PM