Xante ScreenWriter Colour ScreenWriter, User Manual

Page: 45 / 446

__________________________________________ Installation 2-15
4. Remove the old oil bottle from the printer if you are replacing
it using the following procedure.
a. Slide a clean sheet of paper under the oil bottle as you
pull it up and out to prevent a spill.
b. Use a clean, lint-free cloth or paper towel to absorb any
remaining oil from the bottle area inside the printer.
Note: If a large spill occurs, use the oil syringe
included with the printer’s starter kit to remove
the majority of the excess oil; then use the cloth
or paper towel to absorb the rest.
c. Dispose of the old oil bottle following all applicable
safety laws and regulations.
5. Hold the new oil bottle nozzle down and lower it into the
printer (fig. 2.17).
Oil Bottle
Fig. 2.17 Install the Oil Bottle
6. Close the oil bottle locks (fig. 2.16). If this is the initial printer
installation, skip to step 3 in the next section, “Installing or
Replacing the Cleaning Roller.” If not, close the printer’s top
cover and continue to step 7.
7. Turn on the printer’s power.