X-Tronic 9010-PRO, Instructions Manual

Page: 8 / 16

- 6 -
OPERATING GUIDELINES
General Set-up & Use
1. Before turning on the unit, choose the nozzle that will be used and
install it on the gun. (see page 9 for how to change nozzles).
Note: All new nozzle tips have solder in the tip hole to prevent
oxidation during first use. Once the unit heats up, the solder
will melt and reveal the hole.
2. Ensure that the desolder gun is in the holder.
Note: The desolder gun needs to be in the holder EVERY TIME
the unit is started.This is a saftey feature and the unit will not work
correctly if this is not followed.
3. Ensure there are no obstructions or blockages in the desolder gun
and/or attachments.
4. Turn on the the switch on the front of the unit.
5. Set the desired temperature by pressing the Temperature
Increase or Decrease Button until the desired temperature
displays on the screen.
6. IMPORTANT:
After the Desoldering Gun has reached its set
temperature, PLEASE ALLOW another 2 minutes to fully preheat
before using the desoldering gun. Failure to do so may cause
clogging.
7. When the desolder gun is in the holder and inactive for 1 minute
(the default setting or whatever the sleep timer is set at) the unit
will go to into “Sleep Mode” and cool down to 392°F / 200°C.
8. To activate the desolder gun after it has been in “Sleep Mode”
pull the trigger and then allow it to warm back up to the set
temperature.
9. After using the desoldering gun, place it back into the holder.
10. When finished using the unit, the power can be turned off.
Note: If the unit will not be used for more than 12 hours, the unit
should also be unplugged from the wall as a safety precaution.