X-Tronic 9010-PRO, Instructions Manual

Page: 7 / 16

- 5 -
PRODUCT SET-UP
1. Unpack all of the contents of the X-Tronic 9050-PRO unit.
2. Inspect the unit and accessories for any damage. If damage
is detected, please contact X-Tronic immediately (see back of
manual for contact information).
3. Connect the vacuum tube from desoldering gun to vacuum port
on the front panel of the main unit.
4. Verify the filter chamber tube, spring filter, fiber filter, & vacuum
port filter are all installed.
5. Place the desolder gun in the holder.
6. Plug in the power cord to the back of the unit.
7. Plug the 3-Prong AC cord into a 110/120V grounded outlet to
prevent electric shock or injury.
8. The unit is now ready to be powered on with the switch located on
the front of the unit.
SAFETY PRECAUTIONS
Operating the X-Tronic 9010-PRO desoldering station incorrectly may
cause damage to the equipment or the operator. When using this
product, the following basic measures should be strictly followed to
avoid hazards of electric shock, bodily injury, or fire.
1. When powered on, the suction tip temperature can exceed
752°F(400°C) -
2. Do not use near flammable or explosive objects
3. This unit is to be used for desoldering purposes only
4. Turn off power to unit when not in use
5. Unplug unit from AC wall outlet if it will not be used for an
extended period
6. The proper three-wire grounded plug must always be used to
ensure proper operation
7. The units desoldering gun is delicate. Do not tap it against any
surface to remove residues
8. This unit may smoke when powered on for the first time. Powering
up in a well-ventilated area is recommended