- 5 -
INITIAL SET-UP
1. Unpack all of the contents of the X-Tronic #5040-XR3 kit.
2. Inspect the unit and accessories for any damage. If damage is
detected, please contact X-Tronic immediately.
3. Assemble the hands-free telescopic hot air gun holder
Thumb Screw
U-Shaped Bracket
L-Bracket
Silver Retaining
Collar
Vertical Hot Air
Gun Holder
Metal Rod
Note: The Vertical Hot Air Gun Holder and Silver Retaining Collar will be
further up on the Metal Rod when fully assembled.
a. Slide the silver retaining collar onto the metal rod. Install one of
the small dark gray screws into the hole on the silver retaining
collar to secure its placing on the metal rod.
b. Attach the L-bracket to the bottom of the metal rod using the
large silver screw.
c. Attach the L-bracket and rod assembly to the back of the unit
using the 2 holes in the lower center and 2 of the smaller dark
gray screws.
d. Secure the rod to the back of the unit using the U-shaped
bracket and the last two of the smaller dark gray screws.
e. Slide the vertical hot air gun holder assembly over the rod
and secure it with the included thumb screw. Adjust the silver
retaining collar so it is just below the hot air gun holder assembly
to provide additional support.
f. Insert the 4 black thumb screws into the adjustable rail system
around the IR Preheating Plate.
4. Attach the soldering iron to the unit using the soldering iron
connection.
5. Place the soldering iron into the soldering iron holder.
