s t e r e o D S P p o w e r a m p l i f i e r
a m p l i f i e r s
SPECIFICATION
Power supply:
XT 3400:
2 x 1700 W
RMS (4Ω) 2 x 1000W (8Ω)
XT 2600:
2 x 1300 W
RMS (4Ω) 2 x 850W (8Ω)
XT 2000:
2 x 1000 W
RMS (4Ω) 2 x 650W (8Ω)
SNR: >90dB
THD+N: 0.08%@1kHz
IMD: 0.18%, 1kHz@1W
Frequency response: 20-20kHz(+0,-0.5dB)
Input sensitivity/impedance: 0dB(0.775Vrms)/30kΩ
Crosstalk: >50dB
Damping factor: >500:1 @1kHz/8Ω
Phase response: -18 @20Hz, +25 @20kHz
Voltage gain: 40dB@1kHz/8Ω
Protection DC, overload, thermal and shorted protection
Standard power: AC220V 10% 50-60Hz
Dimensions: 483 x 132 x 495 mm
Gross weight:
41 Kg (XT 3400)
39 Kg (XT 2600)
35 Kg (XT 2000)
CONNECTOR CABLE
The following diagrams illustrate the wiring of the various types
of sockets that can be used with the XT power amplifiers.
To connect the amplifier to the mixer, be always sure to use
only signal cables (screened cables made up of two wires plus
a braid screen ), not power cables (speaker cables, normally
made up of two wires, usually with a greater cross-section):
the use of unscreened cables could in fact cause annoying
buzzes and background noise.
We therefore always suggest the use of balanced cables for
m i c ro p h o n e s a n d l i n e u n i t s w h e n e v e r p o s s i b l e .
To connect the amplifier to the loudspeaker enclosures, always
use only power cables, not signal cables, as in the latter case
in fact, the power from the amplifiers would partially be dispersed
because of the cable's smaller cross-section.
Take care of the connector cables. Always hold them by the
connectors, avoiding pulling the wire and avoid knots and twists
when coiling them: this gives the advantage of increasing their
life and reliability.
Check your cables periodically, be sure that they are in good
condition, that the connectors are correctly wired and contacts
perfectly efficient: in fact, many problems and setbacks (faulty
contacts, ground hum, disturbance, etc.) are due to the use of
unsuitable of faulty cables.
X
-
T
R
E
M
E
7
X
-TREME
via Monti Urali, 31 - 42029 Reggio Emilia (Italy) • ph. +39 - 0522 - 557735 • fax +39 - 0522 - 393733 • e-mail: [email protected]
