s t e r e o D S P p o w e r a m p l i f i e r
a m p l i f i e r s
• FRONT PANEL
CONTROL PANEL
• REAR PANEL
1.
CHA: channel A volume adjustment;
2.
CHB: channel B volume adjustment;
3.
Input interface to PC;
4.
Output interface to other unit pc port;
5.
2 x 20 LCD display with backlit;
6.
Power: ON/OFF.
1.
Balanced input (0dB/30 kΩ): for all the models, both CHA
and CHB have one pair of balanced input with cannon connector.
2.
Power output: output should be connected to the loudspeaker.
The CHA/CHB outputs of DSP series amplifier have one
waterproof jack and one group of binding post.
Note:
the rated power and the impedance load of loudspeaker
or loudspeaker system must match the amplifier (see technical
specification). Please use speaker cable only (normally provided
with one red and one black wire). Do not use the signal cable
(normally used for microphone and audio equipment).
3.
Earthed ON/FLOATING. Separate the signal earth from the
chassis. Using this selector to break earth loops which can form
when several units are connected.
4.
Power: AC 220V 10% 50-60Hz.
5.
Air vents.
Note:
the fan of the DSP series cooling system
creates a flow of air with the direction from front to back. That
means the air is taken from the opening on the front and is
expelled through the opening on the back after cooling the heat
sinks and transformer. Attention must be paid to avoid blocking
these openings.
6
4
3
5
2
1
X
-
T
R
E
M
E
3
X
-TREME
via Monti Urali, 31 - 42029 Reggio Emilia (Italy) • ph. +39 - 0522 - 557735 • fax +39 - 0522 - 393733 • e-mail: [email protected]
