ONLINE MODE
A.
Connect the amplifier to PC with the supplied cable: insert
one end of cable into serial port of PC and the other end into
the PC REMOTE in the front panel of amplifier. Start DSP6_48dB
interface software.
B.
CONNECTION.
Click the Tools button and then click
Connect.
CONNECT SUCCESSFUL
PC_CONTROL DEVICE
At that time, the system can be tested by DSP6 software. All
the functions under the offline mode are not valid.
C.
DISCONNECT.
Click Debug button and then click Disconnect,
the LCD shows as follows:
CONNECT CANCEL
MCU_CONTROL DEVICE
Then the software testing is not valid. The system return the
offline mode. Regarding the operation of DSP6 software, please
refer to the online help of it.
PC SOFTWARE
s t e r e o D S P p o w e r a m p l i f i e r
a m p l i f i e r s
X
-
T
R
E
M
E
5
X
-TREME
via Monti Urali, 31 - 42029 Reggio Emilia (Italy) • ph. +39 - 0522 - 557735 • fax +39 - 0522 - 393733 • e-mail: [email protected]
Select one device number(1-255). If this number is the same as
the amplifier ID, the LCD shows as follows:
MENU COMMAND
File menu
New:
create a new File.
Open:
opens an existing File to set.
Save:
save current setting to Disk File.
Memory:
opens DSP6 Memory precinct management menu
Mode menu
Stereo:
stereo mode, the input and output of left and right
channel is independent.
Bridge:
bridge mode, the output phase of left and right channel
is reverse.
Mono:
mono mode, the output phase of left and right channel
is same.
Test menu
Sine wave:
sine wave Test.
Noise:
white noise Test.
