8
2.) HANDLEBAR INSTALLATION
3.) FACE COVER INSTALLATION
1.
Locate and remove the handlebar bolt,
washer & nut as shown above.
2.
Slide handlebars over post in the correct
position, then insert the bolt & concave
washer into the front (speedometer side) of
the handlebars and secure with nut on the
back (riders side). Concave washer should
be partially inserted into the handlebar and
make contact with internal post to be
tightened properly and securely.
1.
Locate and remove packing material
from the face cover.
2.
Line up face cover to front of
scooter being careful not to break the
plastic clips underneath.
3.
Slide the face cover into place and
snap.
4.
Finally, secure to front of scooter
using the 2 enclosed screws.
