the house, or is at some distance from the CO alarm.
Troubleshooting
PROBLEM
SOLUTION
Your alarm does not sound during testing.
Please ensure the batteries are properly installed in the alarm.
Make sure you push thetest button firmly.
Check the installation positioning. The wireless signal might be
blocked or out of range.
The LED flashes yellowonce every 60
seconds with one beep.
The battery is low.
Replace the battery immediately.
The LED flashes yellowtwice every60
seconds with 2 beeps.
The alarm is malfunctioning. Please clean youralarm and see if it is
working normally.If not,
replace the device immediately.
The LED flashes yellow3 times every 60
seconds with 3 beeps.
The maximum lifetime(10 years) is reached.
Replace the alarm
immediately.
If immediate replacement is not possible, you may push
the Test/Silence button once to silence for 22 hours.
FCC Statement
This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part
15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a
residential installation. This equipment generates uses and can radiate radio frequency energy and, if not installed
and used in accordance with the instructions, may cause harmful interference to radio communications. However,
there is no guarantee that interference will not occur in a particular installation. If this equipment does cause
harmful interference to radio or television reception, which can be determined by turning the equipment off and on,
the user is encouraged to try to correct the interference by one or more of the following measures:
-- Reorient or relocate the receiving antenna.
-- Increase the separation between the equipment and receiver.
-- Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
-- Consult the dealer or an experienced radio/TV technician for help.
Changes or modifications not expressly approved by the party responsible for compliance could void the user's
authority to operate the equipment.
This device complies with part 15 of the FCC Rules. Operation is subject to the following two conditions:
(1) This device may not cause harmful interference, and (2) this device must accept any interference received,
including interference that may cause undesired operation.
