XC01-WR
Before use, pull out the battery insulating film from the battery compartment to power
on the device. After the device is turned on, the buzzer will beep once, the LCD
backlight will light up, and the LED indicator will flash through 8 cycles
(yellow/green/red). The device will then enter standby mode.
WARNING
CONSTANT EXPOSURE TO HIGH OR LOW TEMPERATURES AND HIGH
HUMIDITY MAY REDUCE BATTERY LIFE.
Wall Mounting
1.
Choose a suitable installation location by referring to the ―Where to Install‖
section.
2.
Remove the indication sticker from the packaging and refer to the hole locations on
the sticker. Draw two screw holes according to the size and layout of the mounting
holes on the back of the product. Drill the screw holes1.18 inches (30 mm) deep using
aØ 1/4-inch (6.0 mm) drill bit. Note that the distance between the center of the two
holes is2.9 inches (74 mm).
3. Insert the anchor plug into the screw hole and hammer it in until the head of the
anchor plug is flush with the wall.
4. Use the two provided screws or 3.5 × 25 mm countersunk screws to screw into the
two anchor plugs. Be sure to leave a1/5-inch (5 mm) gap between the head of the
anchor plugs and the screws, which will allow for easy device mounting.
