How to Disconnect
Quickly press the TEST/HUSH button 4 times; the alarm will beep once. Then, hold down the button until it beeps once
more to disconnect. After disconnecting, it can be reconnected to the same network, or added to a new network.
NOTE: The X-Sense Link
+
wirelessinterlinked alarms in one multi-pack have already been interconnected. To create
a new network, you will first need to disconnect each alarm individually in this multi-pack to avoid having them all
join the same network.
Alarm Test
Be sure to test your CO alarms when you turn them on for the first time, or if the group configuration has changed. In
addition to the weekly tests you should perform, it is recommended to test the alarm after returning from a long trip or
vacation.
If your X-Sense Link
+
CO03D-W is interconnected to other X-Sense wireless alarms, we recommend that every
individual CO alarm be tested during the weekly test.
Test a single CO alarm
Test all interconnected CO alarms
Action
Press the TEST/HUSH button.
Hold down theTEST/HUSH button.
Indication
The LCD will turn on and display
“---,” “PAS,” and then “0.”
The alarm will emit 2 sets of 4
quick beeps every 5.8 seconds.
The red LED will flash during the
audible signal.
After testing, the alarm will
automatically enter standby mode.
The initiatingunit will beep continuously with the red
LED flashing.
Other interconnected alarms in the network will
receive the signal after 5 seconds, then they will beep
continuously with the red and green LEDs flashing
successively. Release the test/hush button on the
initiating unit and all the units will stop testing.
The testing of the units should be completed within
3 minutes.
After testing, the units will automatically enter
standby mode.
NOTE:
The test function accurately tests the alarm’s CO sensing circuit without the need totest
with CO
. If your CO
alarm fails to emit an audible test signal, refer to the troubleshooting guide at the end of this manual immediately.
